Setting up a Brick Paver Walkway or Engineering Bricks

The usage of Bricks or Pavers to develop a sidewalk or patio area complements a home in a way that is unmatched. In addition, setting up a Brick or Paver sidewalk does not always require a pro.

The key to setting up a Brick or Paver Walkway is to very first appropriately prepare the area where the bricks/pavers are to be installed. The location must be dug out a minimum of a foot down, eliminating all topsoil and clay soil. In addition, string lines ought to be strung on each side of the walkway. The string lines indicate the ended up height of the pathway.
Once the location has been dug down, 3/4" gravel stone should be laid in and tamped down firmly. The height between the tamped down sand and the stringline must equal the thickness of the brick or paver.

Now that you have a steady base, put a 1" pipeline or ledger board the length of the pathway on either side of the walkway. Using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will develop a level surface area to lay the bricks/pavers.

Now location on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the prepared location. These strips will act as your sidewalk border and help to preserve the integrity and shape of the pathway.

The key to laying the bricks/pavers is to ensure that they interlock with each other. Constantly stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will once again help preserve the stability of the walkway.

When constructing the sidewalk, inevitably bricks/pavers will require to be cut or divided. Unless you wish to buy or rent a costly wetsaw, I would suggest buying an easy brick/paver splitter. It is essentially a chisel with a broad end that is the width of the bricks/pavers. To really cut/split the brick/paver, lay it in a bed of sand and place the chisel at a 75 degree angle over the area where you want to break the brick. Utilizing a hammer strike the butt end of the chisel strongly. You might need to do this a number of times. You might likewise want to flip here the brick/paver over and strike the other side of the brick utilizing the hammer and chisle. Within a couple of strikes the brick/paver ought to break cleanly. , if your sidewalk has curves you will need to buy/rent a wetsaw.

.

After installing the bricks, develop up the outdoors edges with additional sand, and then shovel in the topsoil and load down firmly.
Spread stone dust over the new walkway and sweep into the cracks. This will complete the interlocking of the bricks and assist to remove any weed growth.


In addition, setting up a Brick or Paver walkway does not always need a pro. The key to installing a Brick or Paver Walkway is to first appropriately prepare the area where the bricks/pavers are to be installed. Now that you have a steady base, put a 1" pipeline or ledger board the length of the walkway on either side of the sidewalk. These strips will act as your walkway border and assistance to preserve the integrity and shape of the sidewalk. Undoubtedly bricks/pavers will require to be cut or split when developing the pathway.

Leave a Reply

Your email address will not be published. Required fields are marked *